When installing the LCD screen lifter on site, pay special attention to the following issues:

1. Unpack the package, and be careful not to leave the power cord and warranty card in the box.
2. The anti-vibration screw must be removed first, only a Torx screwdriver can be used, not an electric device. Re-energize to lift and make sure that the lifter is not damaged.

3. Before installing the monitor, first try the monitor on the opening of the lifter panel to see if it can fit in. Then fix the monitor on the lifter. Lower the display again.

4. When installing the elevator into the conference table, remember not to let the elevator hang on the conference table. It is recommended to put a layer of cardboard on the table top first, and stand on the table by one person, and the person below will pass the lifter to the person on the table, and the person on the table will slowly put the lifter into the hole to lift it up The device does not touch the desktop to prevent scratches.

5. Connect the power cord again, and use the remote control to move up and down uniformly. In the unified lifting, if there is something that does not lift, please refer to the manual in the remote control bag to restore the code of this lift so that it can be controlled by the remote control.